|
Fault Geometry and Associated Processes |
Department of Earth Sciences, Bullard Laboratories, Madingley Rise, Madingley Road, Cambridge CB3 0EZ, UK
A world-wide review of fault-plane solutions and focal depths for large normal-faulting earthquakes on the continents shows that the overwhelming majority of such earthquakes nucleate in the depth range 6–15 km on faults dipping between 30 and 60°. In the few cases where levelling or seismic data are good enough, these normal faults are shown to be approximately planar from the surface to their nucleation depth at the base of the brittle crust. There is evidence that, in some cases, as a result of the enormous transitory increase in strain rate during large earthquakes, rupture continues into the normally ‘ductile’ lower crust on surfaces with substantially gentler dips. These low-angle surfaces may be analogous to some of the ‘detachments’ seen in metamorphic core complexes of the western USA, but the nature of the motion on them depends on strain rate as well as on rheological contrasts between the ‘detachments’ and the blocks on either side. Such contrasts, however, are unlikely to introduce substantial curvature to an originally planar shear zone.
If the observed spread in active normal-fault dips is caused by rotation of the faults and the blocks they bound during extension, then a maximum ß value of 1.7 can be accommodated by seismic activity on a single generation of normal faults. With continued extension, either a new generation of steeper faults, cutting the rotated first faults, is likely to form, or the deformation will continue aseismically on faults dipping at less than 30°.
Large earthquakes have not been observed to nucleate on very low-angle (<20°) normal faults within the continental crust anywhere in the world. Such faults can of course move aseismically, but are unlikely to do so on a large scale within the upper crust in areas where steep normal faults are seismically active. Thus extensional models that require concentrated simple shear on large sub-horizontal faults within the brittle upper crust will also require a spatial separation between aseismic, very low-angle faulting and seismic high-angle faulting. Since seismogenic high-angle faults dominate the topography of extending regions, upper-crustal very-low-angle faulting, if it occurs on a large scale, presumably does so in areas that are relatively flat.
This article has been cited by other articles:
 |
|
 |
|
  T. J. Reston The formation of non-volcanic rifted margins by the progressive extension of the lithosphere: the example of the West Iberian margin Geological Society, London, Special Publications, 2007; 282: 77 - 110. [Abstract] [Full Text] [PDF]
|
|
|
|
|
|
C. Mehl, L. Jolivet, O. Lacombe, L. Labrousse, and G. Rimmele Structural evolution of Andros (Cyclades, Greece): a key to the behaviour of a (flat) detachment within an extending continental crust Geological Society, London, Special Publications, 2007; 291: 41 - 73. [Abstract] [Full Text] [PDF]
|
|
|
|
|
|
N. Christie-Blick, M. H. Anders, S. Wills, C. D. Walker, and B. Renik Observations from the Basin and Range Province (western United States) pertinent to the interpretation of regional detachment faults Geological Society, London, Special Publications, 2007; 282: 421 - 441. [Abstract] [Full Text] [PDF]
|
|
|
|
 |
|
 A. Saintot, M.-F. Brunet, F. Yakovlev, M. Sebrier, R. Stephenson, A. Ershov, F. Chalot-Prat, and T. McCann The Mesozoic-Cenozoic tectonic evolution of the Greater Caucasus Geological Society, London, Memoirs, 2006; 32: 277 - 289. [Abstract] [PDF]
|
|
|
|
|
|
F. Gueydan, C. Mehl, and T. Parra Stress-strain rate history of a midcrustal shear zone and the onset of brittle deformation inferred from quartz recrystallized grain size Geological Society, London, Special Publications, 2005; 243: 127 - 142. [Abstract] [PDF]
|
|
|
|
|
|
References Geological Society, London, Memoirs, 2003; 28: 73 - 76. [PDF]
|
|
|
|
|
|
M. Perez-Gussinye, T.J. Reston, and J. Phipps Morgan Serpentinization and magmatism during extension at non-volcanic margins: the effect of initial lithospheric structure Geological Society, London, Special Publications, 2001; 187: 551 - 576. [Abstract] [PDF]
|
|
|
|
|
|
L. Jolivet and M. Patriat Ductile extension and the formation of the Aegean Sea Geological Society, London, Special Publications, 1999; 156: 427 - 456. [Abstract] [PDF]
|
|
|
|
|
|
A. G. Skuce Forward modelling of compaction above normal faults: an example from the Sirte Basin, Libya Geological Society, London, Special Publications, 1996; 99: 135 - 146. [Abstract] [PDF]
|
|
|
|
|
|
K. R. McClay Recent advances in analogue modelling: uses in section interpretation and validation Geological Society, London, Special Publications, 1996; 99: 201 - 225. [Abstract] [PDF]
|
|
|
|
|
|
J. D. Van Wees, S. Cloetingh, and G. de Vicente The role of pre-existing faults in basin evolution: constraints from 2D finite element and 3D flexure models Geological Society, London, Special Publications, 1996; 99: 297 - 320. [Abstract] [PDF]
|
|
|
|
|
|
T. J. Wynn Deformation in the mid to lower continental crust: analogues from Proterozoic shear zones in NW Scotland Geological Society, London, Special Publications, 1995; 95: 225 - 241. [Abstract] [PDF]
|
|
